56 – Tablesaw Setup/Tuneup (Pt. 2)

thewoodwhisperer — Sun, 22 Jun 2008 21:00:06 +0000

In the second and final part of our tablesaw setup series, we continue our quest for fine tuning. Topics include setting the blade bevel angle, adjusting fence alignment with the blade, adjust fence so that it is square to the table, setting up the insert, and lining up the splitter.

And at the end, you will get a nice full view of the new saw. For those who are curious, it is a PM Custom from the folks at Wood Werks Supply.

Back to Part 1

55 – Tablesaw Setup/Tuneup (Pt. 1)

thewoodwhisperer — Fri, 13 Jun 2008 05:35:40 +0000

Our tools are no good to us if they aren’t tuned up properly. As the “heart” of the workshop, its crucial that our tablesaws are configured to perform their best. So whether you are setting up a new saw, or tuning up your current one, this video guide will get you where you need to be. Part 1 covers three different methods for aligning the miter slot to the blade as well as a simple technique for attaching and leveling the extension wings.

I am sure you will also notice that this is a new sexy tablesaw. For those who are curious, it is a PM Custom from the folks at Wood Werks Supply. And even a big fancy saw still requires a good bit of setup and tweaking.

Go to Part 2

***The following clip was cut from the original video. Since the topic of table saw flatness came up in the comments, I decided to throw the clip out there as bonus footage. Enjoy.

The Wood Whisperer » pm2000

56 – Tablesaw Setup/Tuneup (Pt. 2)

55 – Tablesaw Setup/Tuneup (Pt. 1)